Skip to Content

Register Login

Default Header

(header konnte nicht geladen werden)

Navigation

Local / Remote Switching of MM420

Created by: a7914a at: 4/26/2006 5:47 AM (2 Replies)

Rating (0)

Thanks 0

3 Entries

4/26/2006 5:47 AM	Rate (0)
a7914a Posts: 29 Rating: (0)	Hi. I read something onthe part of Control Word 1where bit 15 is used to swtich MicroMaster420between Local or Remote. I tried it out by just enabling or disabling that bit, but to no avail. Did i miss something out? Can anyone help me out? My MM420 firmware version is 1.18. Thanks in advance.
a7914a Posts: 29 Rating: (0)
Suggestion To thank Quote Answer

4/27/2006 6:49 PM	Rate (0)
Shamsher Posts: 102 Rating: (3)	Hello Dear I myself have faced a problem of that sort myself with MM420 but lady luck smiling on me said the setpoints for both the local control post as well the remote location has to come from the same DCS.As far as the start command was concerned the local remote option is there Regards Shamsher
Shamsher Posts: 102 Rating: (3)
Suggestion To thank Quote Answer

4/30/2006 5:27 PM	Rate (0)
Shamsher Posts: 102 Rating: (3)	Dear All One solution is get the firmware updated and that worked in my case Regards Shamsher
Shamsher Posts: 102 Rating: (3)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on