Skip to Content

Register Login

Default Header

(header konnte nicht geladen werden)

Navigation

mm440

Created by: dadkhah at: 7/4/2018 8:41 PM (4 Replies)

Rating (0)

Thanks 1

5 Entries

7/4/2018 8:41 PM	Rate (0)
dadkhah Experienced Member Joined: 6/21/2014 Last visit: 3/8/2025 Posts: 41 Rating: (0)	hello all i have a mm440 drive (6se6440-2ud33-0ea1) with software version v2.17. i couldnt read the drive parameters by drive monitor v5.5. which drive tool is suitable for it and how can i get it ? thanks a lot

Suggestion To thank

7/4/2018 8:49 PM	Rate (0)
ixo65 Grandmaster Joined: 12/18/2014 Last visit: 9/11/2025 Posts: 35949 Rating: (4500)	Please don't post twice. https://support.industry.siemens.com/tf/de/en/posts/mm440-drive-tool/194194/?page=0&pageSize=10#post773044

Suggestion To thank
This contribution was helpful to 1 thankful Users #dP

7/4/2018 9:28 PM
dadkhah Experienced Member Joined: 6/21/2014 Last visit: 3/8/2025 Posts: 41 Rating: (0)	hello ixo65 I wish you had a solution instead of criticism

Suggestion

7/4/2018 9:35 PM	Rate (0)
ixo65 Grandmaster Joined: 12/18/2014 Last visit: 9/11/2025 Posts: 35949 Rating: (4500)	dadkhah hello ixo65 I wish you had a solution instead of criticism Yes, everyone has their wishes ..... Some should wish to understand friendly hints as such ....

Suggestion To thank

7/5/2018 6:42 AM	Rate (0)
Jen_Moderator Diamond Member Joined: 6/19/2017 Last visit: 9/6/2024 Posts: 8171 Rating: (174)	Closed cause question posted twice. The second thread with the subject mm440 drive tool is published within the conference MICROMASTER. Best regards Jen_Moderator

Suggestion To thank

|

Share this page:

Share this page on...

Follow us on