Skip to Content

Register Login

Default Header

(header konnte nicht geladen werden)

Navigation

Wrong scaling when going CCW

Created by: www.opauto.no at: 8/16/2017 1:49 PM (2 Replies)

Rating (0)

Thanks 0

3 Entries

8/16/2017 1:49 PM	Rate (0)
www.opauto.no Posts: 32 Rating: (0)	Hi. I made a completly ommunication block to an Micromaster 420 with profibus and S7-300. It works perfect, but there is one Henche. When i swap the bit that controll the Drive to go Counter clock wise(CCW) the scaling algorythm is not correct. When going Clockwise the scaling is correct. my formula is based on the one given from Siemens: Any idea what my causing this ? RGDS ØP
www.opauto.no Posts: 32 Rating: (0)
Suggestion To thank Quote Answer

9/1/2017 5:15 PM	Rate (0)
Solar-Laso Member Joined: 8/29/2017 Last visit: 11/29/2024 Posts: 10 Rating: (1)	Are you using an absolute value of speed?

Suggestion To thank Quote Answer

9/1/2017 5:21 PM	Rate (0)
Solar-Laso Member Joined: 8/29/2017 Last visit: 11/29/2024 Posts: 10 Rating: (1)	Could you share the formula?, or the link you found it?

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on