Picture please,810D  CCU front with power on , I need see the number and LED's

AutoGen_5425f

Hi,

My CNC Mill is getting stuck at he the Siemens boot screen with flashing lights on the control panel.

Message on the screen is, Waiting for NCK connection.

Is this a battery issue?

Thanks 

 power supply module dead replace it

AutoGen_5425f

I have only had this machine for a short time. I am running it on a 3 phase diesel generator and damaged the power supply because of high voltage.

The generator is now working correctly.

After replacing the power supply the machine powered up correctly. A few days later I powered up and have this problem. A few days later I powered up and working correctly again. Now i have tried multiple times and the machine has this problem. No lights on the CCU in the above picture.

 Yes I can help you for that as well, but you need replace power supply module  asap.

if you like post the power supply label starting with number 6SN1145-xxxxx,

at same time you can PM me.  I can help you to source the power supply and I can find battery number for you for you and then you can start to replace battery

AutoGen_5425f

Thank you for your assistance. Are you able to help with the battery change procedure for this control? Would i get a low battery alarm if the battery is getting old? 

Thank you

 I will send you the produce how replace the battery  

here you are

https://www.scribd.com/document/366255856/810D-Battery-Replecement-Proceduer

AutoGen_5425f

I have ordered a battery from Siemens NZ.

The power supply I have recently purchased is under warranty so I will be returning it for a replacement.

Thank you