SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

Servo operation

9/2/2013 8:21 AM	Rate (0)
Rajesh_s Experienced Member Joined: 10/20/2011 Last visit: 12/12/2024 Posts: 102 Rating: (3)	Gud Mrng to all, Please guide me for the following issue. 1. 3 rd party sevo operation is possible in S7-1200 ? 2. If any External module available for position control opration in S7-1200.

Suggestion To thank Quote Answer

9/3/2013 12:37 PM	Rate (1)
Denilson Pegaia Diamond Expert Joined: 9/23/2005 Last visit: 1/2/2026 Posts: 4435 Rating: (1487)	Hi, it is possible tocommunicatea S7-1200 and 3rd part devices that are PROFINET compatible (as IO Device), for example.However you shoulduse Axistechnological objects with devices that uses PTO interface.
	Denilson Pegaia Siemens Industry Sector Technical Support
Suggestion To thank Quote Answer

9/10/2013 2:19 PM	Rate (1)
William_B Posts: 5225 Rating: (1204)	Hi Rockie, I have done what you are asking. The motion control blocks for the S7-1200 generates pulse and direction signals. This is however open loop.. as if driving a stepper motor. You will not be able to make a closed loop system through the PLC, but you can create coding to monitor the drive or motor progress. PLC coding can then compare what you are asking and what you are getting. Note that some drives already have motion control built in. You can trigger the position via a digital signal or by communication (like CAN or Modbus). Many drive also have the ability to have extra communication modules for Profibus or such. For my purposes the built in pulse and direction worked well enough. TIP: make sure of the type signal required ( NPN / PNP / differential; 5V / 24V ). Does this help you? w
William_B Posts: 5225 Rating: (1204)
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users Denilson Pegaia

9/10/2013 2:58 PM	Rate (0)
William_B Posts: 5225 Rating: (1204)	As bonus.. an example also applicable for 3rd party servo / stepper / inverters http://support.automation.siemens.com/WW/view/en/38391227
William_B Posts: 5225 Rating: (1204)
Suggestion To thank Quote Answer

9/23/2013 7:01 AM	Rate (0)
Rajesh_s Experienced Member Joined: 10/20/2011 Last visit: 12/12/2024 Posts: 102 Rating: (3)	Thanks a lot sir

Suggestion To thank Quote Answer

9/27/2013 12:20 PM	Rate (0)
O_Moderator Diamond Member Joined: 4/24/2009 Last visit: 8/20/2024 Posts: 2682 Rating: (135)	New question splitted to motion control block in S7-1200 plc for servo control Best regards O_Moderator
	Tips&Tricks for the forum usage
Suggestion To thank Quote Answer

Share this page:

Share this page on...