Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

810D

Created by: CNCTECH at: 12/1/2006 7:17 PM (4 Replies)

Rating (0)

Thanks 0

5 Entries

12/1/2006 7:17 PM	Rate (0)
CNCTECH Posts: 3 Rating: (0)	I have VMC with 810D with shopmill, pls. advise me on the flg.: 1. How to lock specific part programs only? thanks
CNCTECH Posts: 3 Rating: (0)
Suggestion To thank Quote Answer

12/6/2006 9:27 AM	Rate (0)
SteveJ Posts: 328 Rating: (29)	Dear User It is possible to alter the properties of individual programs and there prevent the editing of said files. SERVICES > Highlight program > MANAGE DATA > Set READ and WRITE protection levels to desired etc 3. > ACCEPT STARTUP > DELETE PASSWORD. (If password level is set) this will now only give access to Keyswitch level only. Hope this helps Best Regards SteveJ
SteveJ Posts: 328 Rating: (29)
Suggestion To thank Quote Answer

12/6/2006 3:32 PM	Rate (0)
CNCTECH Posts: 3 Rating: (0)	Thanks Steve I will try this give you the feedback. Now, on the same system 810D with Shopmill, I would like to make programs in ISO mode, pls. guide me: How to bring the system to ISO mode? Will I loose my other programs in doing so? Will it require a Siemens expert every time I switch between ISO & Siemens mode? Can I perform cycles in ISO mode? Pls. advise step by step. Also I have one VMC with 802D SLPRO, my issue is - Spindle load meter is dispalyed on the screen but it is not showing the load i.e. I think it is not active, due to this I am facing a lot of problem in saving my tool from breakage. Thank you.
CNCTECH Posts: 3 Rating: (0)
Suggestion To thank Quote Answer

12/12/2006 6:01 PM	Rate (0)
CNCTECH Posts: 3 Rating: (0)	Dear Steve, Thanks for the reply, but there is no such key as "MANAGE DATA" on the screen to lock the specified programs. Pls. help. Thanks Anjay goliya
CNCTECH Posts: 3 Rating: (0)	Last edited by: CNCTECH at: 12/12/2006 6:03 PM
Suggestion To thank Quote Answer

12/20/2006 6:56 PM	Rate (0)
SteveJ Posts: 328 Rating: (29)	Dear Sir You must set the system passord to manufacturer level MANAGE DATA function Best regards SteveJ
SteveJ Posts: 328 Rating: (29)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on