0_Einstein

Set 3900 = 1 (or end commissioning).  It should fix the speed controller missing, which usually also fixes the off1 enable missing.

balintmozes

0_Einstein

Have you used the "Diagnostics" in the project tree shown in the left of your posted image?  How about looking at the missing enables?

If I were to guess, your induction motor needs the motor id commissioning steps performed before it will allow the first enable via profibus. 

balintmozes

Hello,

I am using the following configuration. The drive is in ready state according to the LEDs. It has the enable signals in r46, but won't start.

 

 I activated motor id and the same message popped. 

 I have same problem pls help me

------------------------------------------------------------------------------------------
Split from Switch on disable of the drive is inactive, while drive is in ready.

Hi Mohka,

if you have the same problem.. did you try the answers of 0_einstein? If not.. please try it and then tell us where you are stuck, what hardware you are using etc.. details are needed to get a good answer. 

BR, 

Noodles

8Noodles

Hi Mohka,

if you have the same problem.. did you try the answers of 0_einstein? If not.. please try it and then tell us where you are stuck, what hardware you are using etc.. details are needed to get a good answer. 

BR, 

Noodles

 I have a cu310 2dp and it connected with a plc 300 by Profibus, all telegrams are ok,  signal  of telegram for on off1 off3 and  enable operation and signal cotrol by plc is ok  but ready for switchin on is not active.  safety integrated is  disable.  Through the control panel, the commands are ok and the motor moves.  what is the problem?