DCC Chart is not open

I have problems with open DCC charts into a Sinamics DCM. After establishing connection converter with PG using STARTER we cant open DCC chart. We follow next steps:

1. create new starter project;

2. find accessible nodes via CP5711(PROFIBUS);

3. accept found drives in project;

4. load drive unit to PG (two times with and without option «Overwrite available DCC libraries»)

License for Starter DCC is installed, DCC is not empty.

What we should do to open DCC chart?

Info about installed software:
- OS Windows XP SP3

Hello all,


I have one more question,

first case:

is it possible download back up include dcc chart from drive to a new project in Starter, then  the CU and the Drive bring to factory setting and then download project from PG back to the Drive? Is it possible ?

or second case: if I have to change S120 and I don't have  project inslude source of DCC, Can I perform same steps as case first?

Thank you

Karel

Hi, as i understood, i could:

1.make a new project in Starter and upload project to PG with dcc charts (not readable),

2.reset drive to fabric state,

3.download project from PG to Drive with options (save add. data to file system and dcc charts),

4.ram to rom,

5.reupload project to PG and DCC could become readable? 

am i right?

If i have uploaded from drive to PG, i got message that DCC charts can't open.

My decission is replace s120 book motor unit to new one but more powerfull (x2). 

From s120 manual: in expert list

CU - p0009 = 1

p9906 = 2

p0009 = 0

p0977 = 1

Drive Unit: p0201 = r0200

p0010 = 0

p0971 = 1

I have to RAM to ROM via p0971 = 1, p0977 = 1.

I'm affraid that i would corrupt DCC charts, stored in Drive?

Or RAM to ROM don't rewrite DCC?