Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Regarding SAG compensation on Sinumerik 840D SL

Created by: MNR at: 4/2/2013 7:33 AM (2 Replies)

Rating (0)

Thanks 0

3 Entries

4/2/2013 7:33 AM	Rate (0)
MNR Posts: 30 Rating: (0)	Dear Sir, We have Sinumerik 840D SL with NC software version 1.5+ SP4+HF3 with Safety integrated option. Now we are trying the enter the SAG compenstion via program execution. SAG compensation option is already activated.(below is my program sample) , when i run this program i get error message 17070 Channel 1 block 7 data write protected) and we the program is aborted. Could you please advise, how can i resolve this problem?? METRIC CHANDATA(1) $MA_CEC_ENABLE[AX1]=0 $MA_CEC_ENABLE[AX2]=0 NEWCONF $AN_CEC[5,0]=0 $AN_CEC[5,1]=0 $AN_CEC[5,2]=0 $AN_CEC[5,3]=0 $AN_CEC[5,4]=0 $AN_CEC[5,5]=0 $AN_CEC[5,6]=0 $AN_CEC[5,7]=0 $AN_CEC[5,8]=0 $AN_CEC[5,9]=0 $AN_CEC[5,10]=0 $AN_CEC[5,11]=0.015 $AN_CEC[5,12]=0 $AN_CEC[5,13]=0 $AN_CEC_INPUT_NCU[5]=1 $AN_CEC_INPUT_AXIS[5]=(AX3) $AN_CEC_OUTPUT_NCU[5]=1 $AN_CEC_OUTPUT_AXIS[5]=(AX2) $AN_CEC_STEP[5]=100 $AN_CEC_MIN[5]=0 $AN_CEC_MAX[5]=1300 $AN_CEC_DIRECTION[5]=0 $AN_CEC_MULT_BY_TABLE[5]=0 $AN_CEC_IS_MODULO[5]=0 $MA_CEC_ENABLE[AX2]=1 M17
MNR Posts: 30 Rating: (0)
Suggestion To thank Quote Answer

4/2/2013 7:52 AM	Rate (0)
Ekalavya Posts: 2964 Rating: (482)	Hello, Could you check this linkinformation and do accordingly... /tf/WW/en/Posts/54868 Regards, Prakash
Ekalavya Posts: 2964 Rating: (482)
Suggestion To thank Quote Answer

4/2/2013 7:04 PM	Rate (0)
SteveA Posts: 297 Rating: (41)	You could try programming a STOPRE after the NEWCONF to see if that helps. Note that if you make any changes to the overall settings (Min, Max, Step, etc), they will not take effect until after an NCK Reset. HTH, SteveA
SteveA Posts: 297 Rating: (41)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on