12/3/2016 9:30 AM | |
Posts: 41 Rating: (0) |
Hello. I have bought a second hand Reichenbacher vision II with Sinumerik 840D I am new to this control so bear with me. When I first got the machine and power it up I noticed that all the dashboard lights where blinking, ? why is that ? On the sinumerik 840D drive all the lights where on when I booted with the nr. c in the led ? I see switch 3 was set to 1 and switch 4 was set to 3 when I got it. I tried to make a general reset on the sinumerik 840 D drive but all the lights was on with the number c this happen as soon as power is turned on. does not Mather what position switch 3 and switch 4 is in. I have attached some pictures of my status when booted up. I have 1 question more, on the screen on the cnc control the alarm message refer to "trigger an NCK power on reset" can you explain where i do this? "switch the MMC and NCK off and on again" is this done on the cnc control screen or on the sinumerik drive? Can anyone give me advise on how i proceed from here? As many details as possible. Best Regards. Flemming Attachmentsinumerik 840 boot pictures.zip (141 Downloads) |
12/20/2016 6:31 AM | |
Joined: 10/17/2007 Last visit: 5/5/2024 Posts: 3981 Rating: (340) |
If you get good NCU, you need 1st make PLC and NC data back up . then clean all data, download old back (original machine back up) attached is for PCU50 how to back up NC,PLC --you have MMC103, they have similar steps as your ref.
AttachmentCreating NC-PLC archive backup in PCU50[1].3.pdf (156 Downloads) |
If you like my comments please |
|
12/22/2016 3:48 AM | |
Joined: 10/17/2007 Last visit: 5/5/2024 Posts: 3981 Rating: (340) |
Hi, I found better back up and re-loading steps please find in attachement AttachmentNC_PLC_ Data_Backup_reload.pdf (209 Downloads) |
If you like my comments please |
|
Follow us on