Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

wich data block?

Created by: Andrej at: 10/19/2006 4:01 PM (5 Replies)

Rating (0)

Thanks 0

6 Entries

10/19/2006 4:01 PM	Rate (0)
Andrej Posts: 8 Rating: (0)	Greetings! I would like to know wich data block is adressed to a specific R parameter? For instance for R600. LP A
Andrej Posts: 8 Rating: (0)
Suggestion To thank Quote Answer

10/19/2006 6:22 PM	Rate (0)
SteveJ Posts: 328 Rating: (29)	Hi Andrej To which system are you enquiring? Regards SteveJ
SteveJ Posts: 328 Rating: (29)
Suggestion To thank Quote Answer

10/19/2006 10:11 PM	Rate (0)
bobek Posts: 4 Rating: (0)	andrej kaj bi rad naredil.ker znam le nemško ti svetujem da zastavis uprasanje tako!!! rad bi preko plc spreminjal r parametre na sinum.840d.R param od 600 naprej
bobek Posts: 4 Rating: (0)
Suggestion To thank Quote Answer

10/19/2006 10:14 PM	Rate (0)
bobek Posts: 4 Rating: (0)	Hallo Ich will von der PLC R-parameter in der 840d zu schreiben.Von R600 weiter.
bobek Posts: 4 Rating: (0)
Suggestion To thank Quote Answer

10/20/2006 5:30 AM	Rate (0)
Andrej Posts: 8 Rating: (0)	Hello! I am using sinumerik 840d. And like "bobek" said i would like to assign values to R parameters from PLC. From R600 further... A
Andrej Posts: 8 Rating: (0)
Suggestion To thank Quote Answer

10/20/2006 1:21 PM	Rate (0)
shanny Posts: 44 Rating: (0)	Hi, No easy way on the 840D. You need to use FB3: PUT write NC Variables Look in the DOC on CD 840D Basic Functions / PLC program / Block Decriptions./FB3 There is an example for writing R parameters but it will require the use of NCVAR Selector. There is no data block/dual port ramthat is mapped to the R Parameter area. If you can adapt your requirements to use FC21 to transfer data or even better look at using NCK I/O to do it. Shanny
shanny Posts: 44 Rating: (0)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on