Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

0rientation with BERO

Created by: monu at: 10/17/2013 7:39 AM (3 Replies)

Rating (0)

Thanks 0

4 Entries

10/17/2013 7:39 AM	Rate (0)
monu Posts: 6 Rating: (0)	Dear Sirs I started rerofit the machine with sinumerk 828D. I had connected wiring of BERO to CU pin X122.12(Sinamics DI/O10) and i changed spindle drive parameter p0495=2 according to the manual. When i give spindle command M19(orientation) it does not stop in the same position every time. please let me know the exact procedure of orientation with bero please do the needful With regards dinesh
monu Posts: 6 Rating: (0)
Suggestion To thank Quote Answer

10/18/2013 11:02 AM	Rate (0)
Ayrus Experienced Member Joined: 1/13/2009 Last visit: 10/29/2024 Posts: 19 Rating: (1)	Hi, Set MD34200=7 Regards Syam

Suggestion To thank Quote Answer

10/22/2013 8:55 AM	Rate (0)
syg Advanced Member Joined: 5/22/2009 Last visit: 7/14/2021 Posts: 17 Rating: (0)	please go through attached doc. Attachment C:\Documents and Settings\IN213360\Desktop\BERO in 828D.pdf (240 Downloads)

Suggestion To thank Quote Answer

10/22/2013 3:40 PM	Rate (0)
monu Posts: 6 Rating: (0)	THANK YOU. I WILL TRY THIS WITH REGARDS DINESH
monu Posts: 6 Rating: (0)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on