1212 DC/DC/DC Goes to STOp

Hello luiscq,

Have you tried doing a complete compilation of both hardware and software and trying to load again.

Could you attach a screenshot if you get an error?

 Tell us then it happened?

What you have done before then this STOP mode active and you can't RUN it?

More information would be great to solve your problem.

But like these solutions you need upgrade you HW to your PLC or load completed correctly program

luiscq

Good morning, when I try to put in RUN mode the plc won't let me, looking at the diagnostic I get the following message:

CPU Information: New Boot Information Boot Block(s)

 Pending:  

- HW Config not loaded or loading/modification not completed successfully   
- PLC program not loaded or loading/modification not completed correctly  
- manual hard reboot required  Current operating state of the CPU: STOP   

HW_ID=52

Any ideas?

Thanks​

 

JBS98

Hello luiscq,

Have you tried doing a complete compilation of both hardware and software and trying to load again.

Could you attach a screenshot if you get an error?

 Thats the solution!! Thanks!!