Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

6RA80 DCM FAULT60300

Created by: JUANSANCHEZ at: 11/30/2014 8:36 AM (6 Replies)

Rating (1)

Thanks 2

7 Entries

11/30/2014 8:36 AM	Rate (1)
JUANSANCHEZ Posts: 251 Rating: (11)	Hello, İ am using dcm with simotion D425pn dp . My application is Rotary knife. Sometimes i took this fault F60300 Commutation failure (3) Can any expert help me solve this fault? best regards
JUANSANCHEZ Posts: 251 Rating: (11)
Suggestion To thank Quote Answer

12/1/2014 10:47 AM	Rate (0)
KSN Platinum Member Joined: 8/25/2006 Last visit: 2/18/2025 Posts: 2213 Rating: (280)	Hello. Look at thisthread, try to modify p51580.

Suggestion To thank Quote Answer

12/2/2014 9:14 AM	Rate (0)
JUANSANCHEZ Posts: 251 Rating: (11)	hello,, what should i do this parameter?
JUANSANCHEZ Posts: 251 Rating: (11)
Suggestion To thank Quote Answer

12/2/2014 9:56 AM	Rate (0)
KSN Platinum Member Joined: 8/25/2006 Last visit: 2/18/2025 Posts: 2213 Rating: (280)	Hello. Look at post ofWard2543: Ward2543 I have installed a number of 6RA70 drives as field exciters for DC generators and DC motors, on electrically powered draglines. To prevent nuisance F030 faults, it was necessary to change U580 so that the fault would be triggered by only maximum current actual value. Under dynamic conditions, the "sufficient voltage time area for commutation" and "curvature of the current crest curve" would cause occasional tripping. He change p51580=0100 May be this is your case also? If you are not sure consult with somebody who have a lot of experience in drive.

Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users JUANSANCHEZ

12/3/2014 12:18 PM	Rate (0)
JUANSANCHEZ Posts: 251 Rating: (11)	Hello, P51580 =Commutation monitoring control word / Commut_monit STW Can i change this parameter? it looks monitoring . Now i am not connected drive and i cant see now. best regards
JUANSANCHEZ Posts: 251 Rating: (11)	Last edited by: JUANSANCHEZ at: 12/3/2014 12:19 PM
Suggestion To thank Quote Answer

12/3/2014 12:25 PM	Rate (0)
KSN Platinum Member Joined: 8/25/2006 Last visit: 2/18/2025 Posts: 2213 Rating: (280)	JUANSANCHEZ Can i change this parameter? it looks monitoring . Now i am not connected drive and i cant see now. p... - adjustable parameters (you can read and write) r... - display parameters (read only) So you can change p51580.

Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users JUANSANCHEZ

8/2/2017 7:31 AM	Rate (0)
Jen_Moderator Diamond Member Joined: 6/19/2017 Last visit: 9/6/2024 Posts: 8175 Rating: (174)	New question published by osman.92.35 is split to a separate thread with the subject Problem with Sinamics dcm: F60300 and F60092. Best regards Jen_Moderator

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Related topics by keywords:

Follow us on