Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Acessing PLC IM151-8PN/DP PLC

Created by: COOLRAJ at: 12/21/2009 5:10 PM (2 Replies)

Rating (0)

Thanks 0

3 Entries

12/21/2009 5:10 PM	Rate (0)
COOLRAJ Posts: 28 Rating: (0)	Whenever I connect my laptop to IM151-8PN/DPPLC , the PLC goesneither in STOP mode nor in RUN mode. The STOP LED keeps blinking and I cannot go online. I am not able to clear PLC or reset it. What might be the probable causes for the PLC switching out of run mode when I connect my laptop.I am not able to access this PLC.
COOLRAJ Posts: 28 Rating: (0)	Last edited by: O_Moderator at: 12/23/2009 9:10 PM Last edited by: O_Moderator at: 12/23/2009 9:09 PM new subject after splitting from /tf/WW/en/Posts/37947#top
Suggestion To thank

12/22/2009 4:55 AM	Rate (0)
fritz Diamond Expert Joined: 10/7/2005 Last visit: 6/5/2023 Posts: 2966 Rating: (1025)	fritz I wonder if you either "upset" the Ethernet somehow when you plug your Laptop into the network (e.g. loose Plug in the switch,poor Profinetcable connection in Plug etc.) or if your Laptop perhaps hasthesame IP address as the I/O station? Hello Coolraj have you checked my earlier advise (see also above)?
	Cheers fritz The advice and opinion given in this thread is that of the author and does not necessarily reflect the views of I S Systems Pty Limited. To find out how I S Systems can help you with your automation needs please visit www.issystems.com.au.
Suggestion To thank

12/23/2009 9:13 PM	Rate (0)
O_Moderator Diamond Member Joined: 4/24/2009 Last visit: 2/23/2023 Posts: 2685 Rating: (135)	Thread closed, because question is already published in the thread with the subject Acessing PLC IM151-8PN/DP PLC. Best regards O_Moderator
	Tips&Tricks for the forum usage
Suggestion To thank

|

Share this page:

Share this page on...

Follow us on