CDS use (Command data set)

Hello; please help me;

I want to use two sources of command in order to make change of "Main setpoint scaling" using profibus two bits,

Exemple

word 4 bit 0 is for selecting value 100 of Main setpoint scaling

word 4 bit 1 is for selecting value 200 of Main setpoint scaling

Or even with same bit.

I interconnect the bits of communication with the input CDS as it shown in images below;

but how it is possible to interconnect CDS output to the right parameter p1071

 Hi Salah47,

check out example shown here

Regards

salah47

Hello; please help me;

I want to use two sources of command in order to make change of "Main setpoint scaling" using profibus two bits,

Exemple

word 4 bit 0 is for selecting value 100 of Main setpoint scaling

word 4 bit 1 is for selecting value 200 of Main setpoint scaling

Or even with same bit.

I interconnect the bits of communication with the input CDS as it shown in images below;

but how it is possible to interconnect CDS output to the right parameter p1071