Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Configure PID FM-355 For 4-Wire Transmitter

Created by: padfoot at: 8/26/2014 8:39 AM (3 Replies)

Rating (0)

Thanks 2

4 Entries

8/26/2014 8:39 AM	Rate (0)
padfoot Posts: 33 Rating: (0)	Hi everyone How can I configure a FM-355 function module to work with a 4-wire transmitter? In "Sensor type" window there are options for signal type only. (4..20ma, 0..20 ma, ...) I want to configure the module to work with a 4-wire system so I can test the control procedure with a "Current Source/Calibrator". All answers will be appriciated. Attachment 2014-08-26_110015.jpg (129 Downloads)
padfoot Posts: 33 Rating: (0)
Suggestion To thank Quote Answer

8/27/2014 10:21 AM	Rate (0)
olloy Silver Member Joined: 8/27/2010 Last visit: 4/13/2024 Posts: 417 Rating: (37)	Hi! If I understood your question correct, you can find the information aboutConnection of Current Sensors As Four-Wire Measuring Transducers at page 170 ofthismanual. Page 109 of same manual is about parametrisation. Hope this helps.
	Last edited by: olloy at: 8/27/2014 11:15 AM link repaired
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users padfoot

8/27/2014 10:35 AM	Rate (0)
padfoot Posts: 33 Rating: (0)	Thank you olloy, but I can not download the manual. Would you please attach it here?
padfoot Posts: 33 Rating: (0)
Suggestion To thank Quote Answer

8/27/2014 11:15 AM	Rate (0)
olloy Silver Member Joined: 8/27/2010 Last visit: 4/13/2024 Posts: 417 Rating: (37)	padfoot Thank you olloy, but I can not download the manual. Would you please attach it here? Sorry, my mistake. Should worknow.

Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users padfoot

|

Share this page:

Share this page on...

Follow us on