3/23/2021 10:10 AM | |
Posts: 10 Rating:
|
Hi, I have a Siemens LOGO! 230 RCE - 6ED1052-1FB08-0BA1 and a SYSTEM SENSOR ECO1003 smoke detector I WOULD LIKE TO CONNECT IT WITH MY LOGO but I have some small difficulties, can someone give me some advice? Use Soft Comfort 8.3 ------------------------------------------------------------------------------------------ |
Last edited by: AntonioValentin at: 03/23/2021 10:13:41Last edited by: AntonioValentin at: 03/23/2021 10:19:35Last edited by: Jen_Moderator at: 03/23/2021 13:45:14New subject after splitting |
|
3/23/2021 10:17 AM | |
Posts: 10 Rating:
|
In my case I could use your example, since my detector only emits a signal (smoke presence)
|
3/23/2021 10:21 AM | |
Joined: 12/18/2014 Last visit: 8/22/2024 Posts: 33604 Rating:
|
Have you a data sheet of this sensor? |
3/23/2021 10:24 AM | |
Posts: 10 Rating:
|
technical data sheet attached AttachmentI56-1653-021 ECO1003.pdf (249 Downloads) |
3/23/2021 10:32 AM | |
Joined: 12/18/2014 Last visit: 8/22/2024 Posts: 33604 Rating:
|
in the data sheet are 8 different types listed. Which type have you exact? |
3/23/2021 10:36 AM | |
Posts: 10 Rating:
|
HERE IS THE SENSOR I OWN |
3/23/2021 11:08 AM | |
Joined: 12/18/2014 Last visit: 8/22/2024 Posts: 33604 Rating:
|
The senor has a relay output. But in the data sheet is not to read, if you can switch 230V AC over the relay contacts.
AttachmentScreenshots.zip (281 Downloads) |
3/23/2021 11:15 AM | |
Posts: 10 Rating:
|
ok thank you, as an example of program to make it work, I take your example earlier that you published in 2017? |
Follow us on