Convert Protool to WinCC Flexible

Hello all,

I need to do some modifications in one HMI screen, whose visualization was programmed with Protool. But, since this software is obsolete and does not work in Windows 10, I need to convert it to WinCC flexible. The problem is that I tried to migrate the file .pdb by opening it with WinCC, according to migration manual, but it didn't work.

Can anyone tell me how can I migrate to WinCC so I am able to work with it and load it to the HMI screen?

Find attached the program with the Protool files stored in the folder TDOP.

Thank you in advance

Best regards

------------------------------------------------------------------------------------------
Split from Protool to WinCC Flexible 2008 SP3.

rename the files to

Pdn_pm4_20221215.zip.001

Pdn_pm4_20221215.zip.002

Pdn_pm4_20221215.zip.003

and try extract with 7zip again

I named them according to what you said but Winrar does not recognize them. I tried to put a shorter name but the fault is the same. It says somtehing like 'It can not open the file .zip and that 'System can not find the specified file', 'file is damaged'. The attached file means this but in spanish.

Hello Cristoph,

I unzipped the files you sent me with the software 7-zip but there are still some fauts when I do it and, when I try to open the files PROJECT_1.hmi or PROJECT_2.hmi with WinCC it appears an error message. All of this faults are showed in the pdf attached. It might be possible that some of the files are corrupt and that's why I can not open them?

Thank you

Best regards

please use exactly the names i write in the above post.

have tested it on my systems and extract and opening work without any problem