Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

CU305 DP do position control

Created by: Dreamer of NZ at: 3/17/2011 9:16 AM (1 Replies)

Rating (0)

Thanks 0

2 Entries

3/17/2011 9:16 AM	Rate (0)
Dreamer of NZ Experienced Member Joined: 10/15/2008 Last visit: 4/6/2022 Posts: 35 Rating: (1)	Hello, everyone, I have one CU305 DP, onePM340, one 1FK7 motor. I want to do position control via CU305 PTO interface(CU305 DP/X23), I know this PTO interface was can accept PNP type, but my PLC is MItisubishi, it only could output NPN PTO, what kind of solution that I can do to resolve this problem?

Suggestion To thank Quote Answer

3/17/2011 1:21 PM	Rate (0)
DenisMor Posts: 344 Rating: (50)	Take a look at this online post. One thing to watch out for is the reaction time/frequency of the device/solution you are using.
DenisMor Posts: 344 Rating: (50)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Related topics by keywords:

SINAMICS_S

Follow us on