Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Direction change clockwise and anti clockwise

Created by: Hammad samar at: 11/17/2020 11:48 AM (3 Replies)

Rating (0)

Thanks 0

4 Entries

11/17/2020 11:48 AM	Rate (0)
Hammad samar Posts: 6 Rating: (0)	hello sir how simoreg dc drive 6ra70 direction change clockwise and anti clockwise ------------------------------------------------------------------------------------------ Split from Sometimes drive display shows only 10.0 and led does not show any mode.
Hammad samar Posts: 6 Rating: (0)	Last edited by: Jen_Moderator at: 11/17/2020 13:51:18 New subject after splitting
Suggestion To thank Quote Answer

11/17/2020 12:16 PM	Rate (0)
PISCEAN 2010 Diamond Expert Joined: 4/23/2010 Last visit: 11/14/2024 Posts: 8092 Rating: (878)	Hammad samar hello sir how simoreg dc drive 6ra70 direction change clockwise and anti clockwise Hello, Have you refer SIMOREG DC-MASTER 6RA70; software version 3.1 manual? Please study it carefully. As suggested in earlier posts, have you checked the STATUS of OFF signals? Please check, if OFF command is being applied to drive.
	Last edited by: Jen_Moderator at: 11/17/2020 13:52:46 Optimized link.
Suggestion To thank Quote Answer

11/26/2020 1:04 PM	Rate (0)
Hammad samar Posts: 6 Rating: (0)	i am facing problem s7300 plc to drive connected profibus card through on the two drive connected the machine from hmi one drive on and one drive not on from plc .drive and plc not show any fault .drive also change but problem not solved so please suggest me how fixed this
Hammad samar Posts: 6 Rating: (0)	Last edited by: Hammad samar at: 11/26/2020 13:09:12
Suggestion To thank Quote Answer

11/27/2020 5:22 AM	Rate (0)
PISCEAN 2010 Diamond Expert Joined: 4/23/2010 Last visit: 11/14/2024 Posts: 8092 Rating: (878)	Hello, What problem do you face? Are 2 drives 6RA70 connected to S7-300 PLC? If yes,which is CPU? Are both drives connected via Profibus? Are both drives are controlled i.e. made ON-OFF speed variation etc. etc. via HMI? If yes which is HMI & OP? Is only one drive is running & other does not run? Also no any fault or alarm is displayed on PLC, drive & HMI? Is it correct? If yes, have you checked connection between HMI & drive? Which type it is? Please provide detail information.

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on