Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

DNP3 and ET200s

Created by: bijan at: 10/21/2014 1:31 PM (2 Replies)

Rating (0)

Thanks 0

3 Entries

10/21/2014 1:31 PM	Rate (0)
bijan Bronze Member Joined: 1/17/2007 Last visit: 8/1/2023 Posts: 115 Rating: (2)	Hi I have 30 ET200S as RTU/CPU in wells and a HMI system(not wincc) in the control room.I want to connect HMI to ET200S via DNP3 Protocol. Is it any solution ?
	Last edited by: bijan at: 10/26/2014 7:53 AM Best Regards Bijan
Suggestion To thank Quote Answer

10/28/2014 7:48 PM	Rate (0)
Navnag Platinum Expert Joined: 11/21/2007 Last visit: 8/22/2023 Posts: 2321 Rating: (304)	Hello bijan When you say ET200S, I understand that you are using ET200S CPUs IM151-7 / IM 151-8 . Is that correct ? What exactly is the configuration of each system on the wells ? how do you want to communicate with HMI ? .... Distance ? WIred / wireless ? Cheers Navnag
	There is no such thing as the last bug in a program There are no stubborn bugs, There are only stubborn Debuggers.
Suggestion To thank Quote Answer

10/29/2014 10:17 AM	Rate (0)
bijan Bronze Member Joined: 1/17/2007 Last visit: 8/1/2023 Posts: 115 Rating: (2)	Hi Navnag Config of wells are IM151-8+2DI+1DO+1AI and must be monitored wirelessly(about 10km).
	Last edited by: bijan at: 10/29/2014 10:18 AM Best Regards Bijan
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on