Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

DP/DP coupler

Created by: JanLan at: 9/18/2012 11:11 AM (3 Replies)

Rating (1)

Thanks 0

4 Entries

9/18/2012 11:11 AM	Rate (0)
JanLan Advanced Member Joined: 10/8/2008 Last visit: 7/23/2023 Posts: 41 Rating: (0)	Hi All, I have a profibusnetwork, in this network a DP/DP coupler is used. Sometimes the cpu goes down because off a fallout of the DP coupler. Is it possible (using software) to find out if the problem is between the cpu and DP coupler, or between the coupler and the client device In the module information, diagnostic buffer I have the event ID #3942, this is refering to the DP/DP module. Thanks, Jan.

Suggestion To thank Quote Answer

9/18/2012 12:18 PM	Rate (0)
Wizard Diamond Expert Joined: 4/24/2006 Last visit: 9/14/2023 Posts: 8592 Rating: (1132)	Hello JanLan, Are you using any Organisation Blocks for error handling? Have a look at this link: Which organization blocks do you need for error handling? Best regards, Wizard

Suggestion To thank Quote Answer

9/18/2012 2:27 PM	Rate (0)
JanLan Advanced Member Joined: 10/8/2008 Last visit: 7/23/2023 Posts: 41 Rating: (0)	Hi, Yes I'm using theOB blocks. In the DP/DP communication with the client, there are signals used for the production. When the clock (garding the communication stops) the production is stoped. This bit is used in combination with the emergency relais. The relais stops the production. In my question I said the cpu stops, this was overdone, the production stops. Using the software I want to find out if the error is one the cpu side, or on the client side Jan

Suggestion To thank Quote Answer

10/1/2012 1:45 PM	Rate (1)
EDL AUTOMATION Posts: 51 Rating: (24)	During Shut Down time, plan for an detail check. By Removing the Profibus cable - between Cpu and client side Dp/Dp coupler. Check one by one and try to find the solution.
EDL AUTOMATION Posts: 51 Rating: (24)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on