Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Error 7000???

Created by: James Hensley at: 4/27/2012 10:12 PM (1 Replies)

Rating (2)

Thanks 3

2 Entries

4/27/2012 10:12 PM	Rate (0)
James Hensley Posts: 1 Rating: (0)	Could someone please explain, dumb down, this error code a little better? 7000 First call with REQ=0: no data transfer active; BUSY has the value 0.
James Hensley Posts: 1 Rating: (0)
Suggestion To thank Quote Answer

4/28/2012 12:18 PM	Rate (2)
jklm Platinum Member Joined: 12/22/2006 Last visit: 1/25/2022 Posts: 1742 Rating: (309)	Hello, This is not an error code but a status. It just tells you that you run into the bloc, but the bloc is doing nothing because the request input REQ = 0 and no other previous job is still running. To start a Job, the input parameter REQ must go from 0 ==>1. This will bring you a code 7001 or 7002 (which again arestatus codes, but not errors) during job execution. Error codes are in the range 8xxx, and theerroroutput parameter= 1 at the same time. Most blocs bring the error bit and the error code only for one CPU cycle.
	Best regards jklm Suggestion was helpful? Feel free to rate it.
Suggestion To thank Quote Answer
This contribution was helpful to 3 thankful Users James Hensley Uzoubir TaTa Aby

|

Share this page:

Share this page on...

Follow us on