F06200 error in infeed

Hi,

We are in the initial stages in configuring a simotion based system where following components are used

1. 6SL3000-0BE21-6DA0(Line filter)
   
2. 6SL3100-0BE21-6AB0(Active interface module)
   
3. 6SL3130-7TE21-6AA4(Active line module)
   
4. 6SL3120-2TE21-8AD0(Double motor module - 18A)
   
5. 6SL3120-2TE13-0AD0(Double motor module - 3A)
   
6. 6SL3420-2TE11-7AA1(Double motor module - 1.7A)
   
7. 6SL3120-1TE21-8AD0(Single motor module - 18A)
   
8. 6SL3120-1TE21-0AD0(Single motor module - 9A)
   
9. 6SL3100-1CE14-0AA0(Capacitor module)
   

Controller is Simotion D435-2 DP/PN with CX32-2 controller extension module. VSM is not there.

When we enable the infeed we are getting F06200 error. We examined the connections and phase voltage to the drive. All are normal. There is no missing phases.

Another point to be noted is that this issue happens when we simply enable the infeed. We didnt configured the drive in the program and this is not repeatable. Sometimes infeed works and goes to enabled state without any error. 

Will that because of the capacitor module(which is overloading the DC link)? 

Please suggest.

We are not getting this error every time. Once the error occurred, if we restart the machine, that will go off. Once powered on, there is not problem while in working condition. When we look at the help file. The explanation was like this.

From Help file

Failure overvoltage in one or several line supply phases.
The fault can be output in two operating states:
1. During the switch-on phase of the infeed unit.
The measured line supply angle deviates from the regular characteristic for a 3-phase system - the PLL cannot be synchronized.
The fault occurs immediately after switch-on if, when operating with a Voltage Sensing Module (VSM), the phase assignment L1, L2, L3 at the VSM differs from the phase assignment at the power unit.

Remedy 

Remedy:
- check the line supply, terminals and fuses.
- check the connection and size (rating) of the line line filter and/or the line commutating reactor.
- check and correct the phase assignment at the VSM (X521 or X522) and at the power unit.
- check the load.
- if failed in operation, carefully note the previous alarm messages A06205/A06206 with alarm values.
See also: p3463 (Infeed phase failure detection line supply angle change)

 We are not using any VSM.

Also we are getting the information message 6400(Line supply identification selected/Active) when the machine starts. Is this a common message. Or do we need to change any parameters? 

Terragna

Hi, I have the same problem. You solved ?