How to find out the parameters P0210 in BOP20?

Hello,

on the SINAMICS S120, goto the Expert list of the CU in STARTER and select p3 = 3.

Then goto the Expert List of your axis, p13[0] = 210.

Then goto the Expert List of the CU again and select p16 = 1.

Then goto your BOP20 and press at the same time "FN" and "Arrow up".

Select then the DriveObject Number of your axis (you can see the DriveObject number at r975[7]) with the Arrrow keys and press "P" to see the user defined list for your BOP which you created with p13. To see the value of p210 press again "P".

Hello,

unfortunately I cannot open the link. Maybe you try out another file sharing method?

Below some information about your alarm F06310.

Hello,

first step: Connect your Notebook to for example the Ethernet port X127 of your CU320-2. This port is directly above your BOP20. Then open the software STARTER. Create an online connection to your device. Then we create your own parameter list, which will be then displayed on your BOP20. But at first, this own parameter list has to be created by doing the following steps:

on the SINAMICS S120, goto the Expert list of the CU in STARTER and select p3 = 3.

Then goto the Expert List of your axis, p13[0] = 210; p13[1] = 70

Then goto the Expert List of the CU again and select p16 = 1.

Then goto your BOP20 and press at the same time "FN" and "Arrow up".

Select then the DriveObject Number of your axis (you can see the DriveObject number at r975[7]) with the Arrrow keys and press "P" to see the user defined list for your BOP which you created with p13. To see the value of p210 press again "P".