how to speed control sinamics s120 cu310-2dp with analog from PLC

Dear Expert!

I have a question, i want to speedcontrol sinamics s120 with 4-20 mA from analog PLC 315-2DP. But when i read function diagram , i can't see parameters P0756, p0757, p0758, p0789 on starter v4.4.

Thank for reading me!

Hello!!!

Check This Attachment.... 

Thanks!

But i can't see it in my starter

dung auto

Thanks!

But i can't see it in my starter

Nothing special!

There are some actions which you have to perform:

• try to get factory settings and perform upload of it back to PC;
  
• configure youre analogue inputs via Starter-> Inputs/Outputs ->Analogue inputs;
• in severe case try to pay attention to p15 where should be set 12 enstead of no selection or so;

Hope this helps!

Cheers

thank all!

I can do it. if i want to speed control how am i to set parameter .P840=?

 Hello!!!

dung auto

Thanks!

But i can't see it in my starter

These Parameters Are Available Under Control Unit

Nothing Required Like Factory Reset And Parameters Change 

Hello!!! 

dung auto

thank all!

I can do it. if i want to speed control how am i to set parameter .P840=?

 Use Some Digital Inputs For ON/OFF (840)

 Hello!!!

dung auto

your idea is use p840= r19 ?

 Check Attachment