Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Migrate WinCC Flexible 2008 SP2 MP377 to TIA Error

Created by: Manie_Devco at: 1/11/2012 9:12 AM (4 Replies)

Rating (0)

Thanks 0

5 Entries

1/11/2012 9:12 AM	Rate (0)
Manie_Devco Posts: 26 Rating: (0)	I am attempting to migrate a MP377 12" Touch project to TIA V11 Professional SP2. I have changed the device in WinCC Flex to the newest version number listed. Error: Device not supported in this version. Please assist
Manie_Devco Posts: 26 Rating: (0)
Suggestion To thank Quote Answer

1/11/2012 9:47 AM	Rate (0)
Manie_Devco Posts: 26 Rating: (0)	Further question... is there no "hardware catalogue update" function as per previous versions ?
Manie_Devco Posts: 26 Rating: (0)
Suggestion To thank Quote Answer

1/11/2012 10:13 AM	Rate (0)
Denilson Pegaia Platinum Expert Joined: 9/23/2005 Last visit: 11/4/2024 Posts: 4351 Rating: (1452)	Hi, If I right understood, you have a WinCC Project with MP377 and try to migrate to TIA Portal. Right? Witch device you try to select? Can you post some printscreens?
	Denilson Pegaia Siemens Industry Sector Technical Support
Suggestion To thank Quote Answer

1/11/2012 10:39 AM	Rate (0)
Manie_Devco Posts: 26 Rating: (0)	I could post some printscreens...just not sure what you would like to see? The Wincc Flexible project was done origionally in 2008 SP1, since then I have installed SP2. The screen used was a MP377 12" Touch v1.0.4.0
Manie_Devco Posts: 26 Rating: (0)
Suggestion To thank Quote Answer

1/11/2012 4:47 PM	Rate (0)
Tweety Posts: 3037 Rating: (192)	Hello, Can you post a screenshot of the error message? Have you open and save the project with WinCC flexible 2008 SP2? Tweety
Tweety Posts: 3037 Rating: (192)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Related topics by keywords:

Follow us on