Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

MPI addressing

Created by: deepak.samal05 at: 3/6/2010 2:56 AM (2 Replies)

Rating (1)

Thanks 0

3 Entries

3/6/2010 2:56 AM	Rate (0)
deepak.samal05 Posts: 65 Rating: (0)	hello guys, what does MPI(1) stands for???? is it node 1 address given by MPI???????? if yes to whom this address has been given because node 0 is given to PG/PC and node 2 to 1st PLC
deepak.samal05 Posts: 65 Rating: (0)
Suggestion To thank Quote Answer

3/6/2010 10:54 PM	Rate (0)
dchartier Grandmaster-Expert Joined: 9/27/2006 Last visit: 12/26/2024 Posts: 12316 Rating: (2695)	Hello deepack; A designation of MPI(1) sounds like3 the typical standardname HWConfig gives to a network when it appears in the Step 7 program. The first time a Profibus network is issued, is is called PROFIBUS(1); if you add a Profibus CP, the network attached to it will be called Profibus(2) unless you change the properties of the bus. Now, MPI nodes can have addresses from 0 to 31 (max. 32 nodes on te MPI bus, per project), and these addresses are attributed sequentially by the program as they are inserted on the bus (CPs, FMs and other CPUs in the project all get one). However, you can change these values if you choose to (or if there is a conflict when imnporting a new station in the project) as long as you do not have 2 elements with similar addresses (the HWConfig editor will block that from happening). Hope this helps, Daniel Chartier

Suggestion To thank Quote Answer

3/16/2010 10:11 AM	Rate (1)
how come Posts: 382 Rating: (47)	Hello deepak.samal05, To add on what Daniel had explained, MPI means Multi-Point Interface. Hope the following attach will be useful to you. with regards, how come Attachment MPI.pdf (407 Downloads)
how come Posts: 382 Rating: (47)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on