Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Not possible to retranslate "softkey cus"?

Created by: Yves_Belgium at: 6/11/2012 7:28 AM (12 Replies)

Rating (0)

Thanks 0

Result pages:: |; 1 | 2; |

13 Entries

Entries per page: 10 | all

6/15/2012 6:13 PM	Rate (0)
Yves_Belgium Posts: 23 Rating: (0)	Hi Ekalavya, thx for reply i´m sorry but i didn´texactly understand what you mean by that Yo mean i should call the Siemens hotline and explain my problem?
Yves_Belgium Posts: 23 Rating: (0)
Suggestion To thank Quote Answer

6/18/2012 5:57 PM	Rate (0)
drill_easy Posts: 54 Rating: (8)	Hi, I tried to load your sc.com and cov.com fragment into my control. The softkeys are shown and the cycle could be created. I also copied a program with your name into the control –Same result (see above). In my opinion, it depends on the cycle name. All Siemens cycles are called Cyclexxx and the cycle support can handle these names. You should rename your program into CYCLEDOFF and try it with that. I believe that the expression cycle must be used at first. Best regards drill_easy
drill_easy Posts: 54 Rating: (8)
Suggestion To thank Quote Answer

6/18/2012 7:40 PM	Rate (0)
Yves_Belgium Posts: 23 Rating: (0)	Yess! finaly a working recompile, and haha that´s all i had to do? i try so many many things, but the name which i see every time was the only thing which i left unchanged thank you! I appreciate it!
Yves_Belgium Posts: 23 Rating: (0)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on