Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

pls help to resolve the problem with 840D

Created by: tomtom at: 10/11/2006 2:23 PM (4 Replies)

Rating (0)

Thanks 0

5 Entries

10/11/2006 2:23 PM	Rate (0)
tomtom Posts: 2 Rating: (0)	Hi. Weaddedsiemens PLC expansionmodule and communication module on the 840D,module type is below: expansionmodule (6ES7 361-3CA01-0AA0) expansioncable (6ES7 368-3BB01-0AA0) communication module (6GK7 343-1EX21-0XE0) The problem is that after a irregular period the 840D system will stop and must be restart. Who can tell me how about this problem and how to resolve it? Thanks.
tomtom Posts: 2 Rating: (0)
Suggestion To thank Quote Answer

10/11/2006 7:18 PM	Rate (0)
SteveJ Posts: 328 Rating: (29)	Dear Sir You must examine the Diagnostic buffer on the PLC CPU, From this buffer, the cause of the stop can be identified. Make anMPI connection to NCU, and copy the project, then go on-line to the PLC.CPUin stop isdenoted by the Stop Icon in the project. then PLC > Diagnostic/setting > HARDWARE DIAGNOSTICS > DIAGNOSTIC BUFFER Best regards SteveJ
SteveJ Posts: 328 Rating: (29)
Suggestion To thank Quote Answer

10/12/2006 3:43 PM	Rate (0)
tomtom Posts: 2 Rating: (0)	Thanks for your reply.[:)] I have got the diagnostic buffer text, but I couldn't found which event is the main problem. Could you help tocheck it? Pls see the attached file. Thanks. Attachment Diagnose.zip (261 Downloads)
tomtom Posts: 2 Rating: (0)
Suggestion To thank Quote Answer

10/14/2006 6:54 PM	Rate (0)
SteveJ Posts: 328 Rating: (29)	Hi Tomtom The event to concentrate on is the one which occurred imediatley after the transition from STOP to RUN, this is event 12 in your log file. It would appear you have a problem witha distributed I/O slave, please check all conected modules, Best regards SteveJ
SteveJ Posts: 328 Rating: (29)
Suggestion To thank Quote Answer

10/19/2006 7:19 PM	Rate (0)
SteveA Posts: 297 Rating: (41)	It looks like you're getting a diagnostic interrupt because an external power supply is missing. You could configure the module to not cause an interrupt, but you should also have OB blocks loaded to respond to these events and not cause a PLC stop.
SteveA Posts: 297 Rating: (41)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on