Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

S5 TO S7 CONVERTING

Created by: ender at: 7/28/2008 3:01 PM (3 Replies)

Rating (0)

Thanks 0

4 Entries

7/28/2008 3:01 PM	Rate (0)
ender Posts: 2 Rating: (0)	Dear Sirs ; I have some problems about S5 to S7 converting.I think S7 does not support some commands.Some of them are TIR , LAR1 , SLW , TAK etc. Because of these commands there are lots of errors about converting. Could you help me How I can convert these S5 commands to S7 commands. With Best Regards
ender Posts: 2 Rating: (0)
Suggestion To thank Quote Answer

7/28/2008 3:53 PM	Rate (0)
Wizard Diamond Member Joined: 4/24/2006 Last visit: 9/14/2023 Posts: 8592 Rating: (1132)	Dear ender, Please have a look at this manual: http://support.automation.siemens.com/WW/view/en/153029 Chapter 3.12 Perhaps it's useful Best regards, Wizard

Suggestion To thank Quote Answer

7/29/2008 9:14 AM	Rate (0)
ender Posts: 2 Rating: (0)	Dear Wizard; I think you sent me wrong document.Your document contains some information about edge evaluation.My question is different. With Best Regards
ender Posts: 2 Rating: (0)
Suggestion To thank Quote Answer

7/30/2008 3:26 PM	Rate (0)
ClaPet Posts: 26 Rating: (0)	Dear ender, The link you are looking for is: 1118413. Regards Peter
ClaPet Posts: 26 Rating: (0)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on