Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

S7-1200 and servo controlled "flying saw" problems

Created by: A.Strand at: 4/15/2011 11:28 AM (4 Replies)

Rating (0)

Thanks 0

5 Entries

4/15/2011 11:28 AM	Rate (0)
A.Strand Posts: 1 Rating: (0)	Flying saw controlled by a servomotor and s7-1200 CPU 1212. We are using the block MOVE VELOCITY to move the axle to the cutting point. That works fine each time and it cuts very exactly. After the cut we sends the axis towards home position with the block HOME in mode 3, distance 0.0. That also works fine at the beginnig the servo finds the reference sensor and does the homing according to the axis configurations. Unfortunately after ex. 70-250 cuttings "cycles" the axis home position moves away from the reference sensor although it performes the block HOME. After the homing is done we sends CLR signal to servodriver. It seems like it could bee some kinde of memory value that is increases and have a affects on the homing procedur ??? How does the homing block work in mode 3 and position 0.0 with reference sensor???? Thanks!!!
A.Strand Posts: 1 Rating: (0)
Suggestion To thank Quote Answer

4/17/2011 6:57 PM	Rate (0)
Marko Bursic Platinum Member Joined: 9/8/2009 Last visit: 3/15/2023 Posts: 1410 Rating: (146)	Have a look at Top Links in this forum, there is also my post with a link to motion control. I would probablymake a debug of application, becaus if it works for 70 times and then goes wrong, the problem might be in your code.Put in monitor instance DB ofHoming procedure and see if there is some error during it, or maybe some other positioning task aborts homming procedure or you add offset to homing position, like you don't reset execute bit of homing and you apply new position before ending homing procedure, or ........

Suggestion To thank Quote Answer

2/13/2013 3:57 PM	Rate (0)
luciferC4 Bronze Member Joined: 1/25/2006 Last visit: 2/9/2023 Posts: 257 Rating: (59)	Hi, Did someone use s7 1200 and TIA portals function block for "flying shear" task and of course, solved it? I am interested because I have some project with this task. I know for easymotion solution by Controltechniques (I worked with it). I ask because I want to use S7 1200 for control automation task all machine which flying shear is part. Thanks

Suggestion To thank Quote Answer

5/19/2015 8:57 AM	Rate (0)
Min_Moderator Platinum Member Joined: 9/3/2014 Last visit: 3/13/2019 Posts: 4827 Rating: (123)	New question published by DougPin is split to a separate thread with the subject flying cutting machine measures very widely. Best regards Min_Moderator

Suggestion To thank Quote Answer

9/6/2017 7:31 AM	Rate (0)
The Helping Hand Moderator Joined: 8/21/2014 Last visit: 3/24/2023 Posts: 701 Rating: (12)	New question published by Vo Trong Nguyen is split to a separate thread with the subject I have an application but i would like to ask you about cutting algorithm. Best regards The Helping Hand
	My Forum is the place to personalize your profile, track your topics, and maintain content that interests you. Best regards The HelpingHand
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Related topics by keywords:

Follow us on