Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

s7200/op7 problem

Created by: senencasio at: 10/3/2007 10:36 PM (1 Replies)

Rating (0)

Thanks 0

2 Entries

10/3/2007 10:36 PM	Rate (0)
senencasio Posts: 1 Rating: (0)	with a working machine i uploaded s7200 226 program and the op7 program( i used prosave on op7). when i downloaded the program to another s7200 226 and op7, and installed this plc and op7 to another machine, one of the function which is to read my length footage is not reading the proper value.i have two input , i think it is for hsc which is i0.0 and i0.6.i read the manual and it shows that i0.6 is designated for hsc 1 and i0.0 for hsc 0.to tell you the truth i'm not familiar with this hsc. but when i look athe ladder diagram the only hsc i can see is hsc 1.my question is, is hsc counter program is also included when i uploaded the program?????.do i need to define the counter mode and inputs when i install it to another plc???? thanks, senen
senencasio Posts: 1 Rating: (0)
Suggestion To thank Quote Answer

10/19/2007 10:59 AM	Rate (0)
Smurf Silver Member Joined: 9/28/2005 Last visit: 10/24/2024 Posts: 414 Rating: (28)	Hi, I suggest that you take a look at TIP04 (How to Use High Speed Counters of the S7-200) of the S7-200 tips & tricks. Have fun.
	Smurf "The only difference between a problem and a solution is that people understand the solution."
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on