Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

TIA portal V13: S7200 to S71200 Converter

Created by: KeithK at: 12/5/2014 9:54 PM (4 Replies)

Rating (0)

Thanks 2

5 Entries

12/5/2014 9:54 PM	Rate (0)
KeithK Posts: 3 Rating: (0)	I have TIA portal V13. S7-Basic. I can't figure out how to convert a S7-200 program to S7-1200. The S7-200 to S7-1200 converter says my software must be version 10.5. The Migration tool from the S7- Pro CD doesn't have an option for files that end in mwp. -------- new subject after Splitting from S7200 to S71200 Converter
KeithK Posts: 3 Rating: (0)	Last edited by: CS Moderator at: 12/7/2014 11:57 PM splitting
Suggestion To thank Quote Answer

12/5/2014 10:41 PM	Rate (0)
William_B Posts: 5225 Rating: (1197)	KeithK I have TIA portal V13. S7-Basic. I can't figure out how to convert a S7-200 program to S7-1200. The S7-200 to S7-1200 converter says my software must be version 10.5. The Migration tool from the S7- Pro CD doesn't have an option for files that end in mwp. There is a version for TIA11. Basically you will have to convert from S7-200 to S7-1200 in TIA. Thereafter you can convert from TIA11 to TIA13. The bad news is that you need the TIA11 software and the converter add-on that goes with it. I am not sure where you can source it.. but there was a thread that handled answered that question. The good news is that you do not need a license for TIA11 if you have a license for TIA13. The license for TIA13 allow (even at the same time) to run TIA11 and/or TIA12. You can probably download the "demo" version of TIA11 which will run as a full version because of your TIA13 license. ..sorry if this was not the answer you hoped for. w
William_B Posts: 5225 Rating: (1197)
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users Ayman Elotaify

12/8/2014 3:13 AM	Rate (0)
KeithK Posts: 3 Rating: (0)	Can't find a download for V11. Should I ask for a demo CD from my vendor, or is there a part number I need to order? Do I need the Pro version?
KeithK Posts: 3 Rating: (0)	Last edited by: KeithK at: 12/8/2014 3:35 AM
Suggestion To thank Quote Answer

12/15/2014 7:39 AM	Rate (0)
Ayman Elotaify Platinum Member Joined: 5/28/2008 Last visit: 12/17/2024 Posts: 4518 Rating: (841)	Hello, You can ask your vendor to do it for you or ask your local Siemens office.
	Ayman Elotaify
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users William_B

4/25/2018 11:04 AM	Rate (0)
Siemens Automatio... Advanced Member Joined: 3/9/2018 Last visit: 9/9/2024 Posts: 57 Rating: (0)	thank you so much i am very grateful to you

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on