TRANSFER THE PROYECT WINCC FLEX - TP177-micro

Mrs.
Myhave the problem is:
It´s not possible downloadny upload the proyect PG a software wincc flexible a hmi TP177 micro,.

What has a acontecen in this problem.........

Transfer to the OP73micro, TP170micro, TP177micro, OP73, OP77A and TP177A HMIs

The "RS232 / PPI Multi Master Cable" (6ES7901-3CB30-0XA0) serial cable is required to transfer project data to the OP73micro, TP170micro, TP177micro, OP73, OP77A and TP177A HMIs. It is imperative that DIL switch 5 is set to 0.

Only serial transfer is possible at micro operating panels. All other HMIs support either serial data transfer or MPI transfer. By changing the transfer mode of a channel in the transfer settings, you disable the corresponding other channel.

OP73, OP77A and TP177A HMIs do not support simultaneous data transfer via MPI from several active instances of WinCCflexible to multiple HMIs. These devices only execute the initial first transfer request.

Best regards.

marce 09

Mrs.
Myhave the problem is:
It´s not possible downloadny upload the proyect PG a software wincc flexible a hmi TP177 micro,.

What has a acontecen in this problem.........

New question published by Kozmoz is split to a separate thread with the subject TP177-micro backup corrupt.

Best regards
Min_Moderator