Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Wincc 7.3 connection with S71200

Created by: Youmbah at: 3/17/2016 9:47 AM (4 Replies)

Rating (3)

Thanks 2

5 Entries

3/17/2016 9:47 AM	Rate (0)
Youmbah Regular Member Joined: 11/20/2015 Last visit: 10/4/2024 Posts: 25 Rating: (0)	Dear Sir I am trying to connect my S71200 KIT with ethernet cable to wicc v7.3 by doing : Tag Management<<Add new driver>> then select <<SIMATIC S7-1200, S7-1500 Channel>> then add new connection under "OMS+", open "Connection Parameters" to configure the IP address. the problem is: The Select the Access point to "S7ONLINE" does not appear , instead i get (CP Ch_1 and PLCSIM) How could i solve this problem please

Suggestion To thank Quote Answer

3/17/2016 10:20 AM	Rate (3)
bg2492 Diamond Member Joined: 5/16/2014 Last visit: 9/12/2022 Posts: 7298 Rating: (2172)	Hello Youmbah, you should create a new Access point with the "PG/PC Interface" for your S7-1200 with the ethernetadapter. Then can you select this Access point in your Connection Parameters Regards Georg Berghof Attachment PGPC_Interface.jpg (685 Downloads)
	PS: If this post did really help you, you may use the Rate-button
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users Youmbah

3/17/2016 9:16 PM	Rate (0)
Youmbah Regular Member Joined: 11/20/2015 Last visit: 10/4/2024 Posts: 25 Rating: (0)	Dear Georg Berghof Thank you so much, your answer was very helpful regards

Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users Min_Moderator

7/31/2017 8:02 AM	Rate (0)
Jen_Moderator Diamond Member Joined: 6/19/2017 Last visit: 9/6/2024 Posts: 8175 Rating: (172)	New question published by Robanel is split to a separate thread with the subject Trying to connect wincc 7.3 with PLC S7-1200 . Best regards Jen_Moderator

Suggestion To thank Quote Answer

7/23/2024 1:08 PM	Rate (0)
a.aras Advanced Member Joined: 11/29/2006 Last visit: 9/16/2024 Posts: 17 Rating: (2)	I encountered the same problem. I installed Simatic Net V18 and defined it to the S7ONLINE ethernet card from the devices.

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Related topics by keywords:

WinCC Communication (OPC, S7, OtherSystem)

Follow us on