Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Rearm the automaton

Created by: DPinho at: 10/30/2015 5:09 PM (2 Replies)

Rating (0)

Thanks 0

3 Entries

10/30/2015 5:09 PM	Rate (0)
DPinho Posts: 1 Rating: (0)	Good afternoon I have a S7-1200 V3.00.02 With thunderstorms, it happened that the PLC went into STOP mode. There will be some way to put the PLC in RUN mode without switching on the PC as the old S7-300 ??? Attachment unicer_linha6v1.jpg (101 Downloads)
DPinho Posts: 1 Rating: (0)
Suggestion To thank Quote Answer

10/30/2015 7:06 PM	Rate (0)
HugoD Posts: 439 Rating: (109)	Hello DPinho, Buy a proper power supply with a surge protector. Where is this PLC? Best regards, Hugo
HugoD Posts: 439 Rating: (109)	Last edited by: HugoD at: 10/30/2015 7:15:55 PM
Suggestion To thank Quote Answer

10/30/2015 7:15 PM	Rate (0)
HugoD Posts: 439 Rating: (109)	DPinho Good afternoon I have a S7-1200 V3.00.02 With thunderstorms, it happened that the PLC went into STOP mode. There will be some way to put the PLC in RUN mode without switching on the PC as the old S7-300 ??? DPinho, To answer your question: Check in the properties of the PLC > Startup > Startup after POWER ON and be sure it is to "Warm restart - RUN" (see attach file) You can set the PLC to RUN via Webserver and also Online & Diagnostic via Programming station Best regards, Hugo Attachment To delete.PNG (88 Downloads)
HugoD Posts: 439 Rating: (109)	Last edited by: HugoD at: 10/30/2015 7:16:44 PM
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on