Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

MP370 connection DP

Created by: ZoranM at: 1/12/2006 3:44 PM (3 Replies)

Rating (0)

Thanks 0

4 Entries

1/12/2006 3:44 PM	Rate (0)
ZoranM Posts: 7 Rating: (0)	I have a problem with MP370 panel. I am trying to configure it to be connected on Profibus DP to PLC CPU314C-2DP. At the start of runtime on MP370 there is the message "Change operating mode to online", and than after 15-20 sec there is the message: 14001 "Connection disconnected", 140015 "Incorrect baud rate or interrupt number set". I am using ProTool/Pro CS V6.0 SP3. I tried to set (in ProTool and Step7) different baud rates but it was the same. I also tried to configure connection to MPI, with MPI cable, but result was the same - no connection. What could be the problem? Thank you.
ZoranM Posts: 7 Rating: (0)
Suggestion To thank Quote Answer

1/12/2006 4:45 PM	Rate (0)
Nemo Posts: 3149 Rating: (171)	Hello ZeroM, please check the transfer settings of your MP370 Transfer settings > advanced > properties > "panel is only master on the bus" must be selected. regards, Nemo
Nemo Posts: 3149 Rating: (171)
Suggestion To thank Quote Answer

1/12/2006 4:52 PM	Rate (0)
ZoranM Posts: 7 Rating: (0)	Hi Nemo. It is selected. Best regards
ZoranM Posts: 7 Rating: (0)
Suggestion To thank Quote Answer

1/12/2006 5:13 PM	Rate (0)
Nemo Posts: 3149 Rating: (171)	Hi ZoranM, can you reach your MP370 via "Options >Set PG-PC Interface"? The following FAQ is giving some hints for fixing Bus-problems: http://support.automation.siemens.com/WW/view/en/19378851 good luck, nemo
Nemo Posts: 3149 Rating: (171)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on