Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

OP270 does not start - Bootloader fails.

Created by: dguillize at: 3/1/2006 5:55 PM (3 Replies)

Rating (0)

Thanks 0

4 Entries

3/1/2006 5:55 PM	Rate (0)
dguillize Posts: 2 Rating: (0)	Sirs, I was updating the firmware (image) of OP270 when somebody turn off the power. Now the OP270 stops in bootloader and I can not do anything. Could you help me ? What can I do ?
dguillize Posts: 2 Rating: (0)
Suggestion To thank Quote Answer

3/2/2006 12:36 PM	Rate (0)
Nemo Posts: 3149 Rating: (171)	Hi, you should useProSave for performing an OS-update via a serial connection http://support.automation.siemens.com/WW/view/en/13031616 http://support.automation.siemens.com/WW/view/en/19701610 http://support.automation.siemens.com/WW/view/en/14293838 http://support.automation.siemens.com/WW/view/en/22110885 nemo
Nemo Posts: 3149 Rating: (171)
Suggestion To thank Quote Answer

3/2/2006 1:06 PM	Rate (0)
dguillize Posts: 2 Rating: (0)	Ok, Thanks, But I have already used these steps on booting. The message that I get on Prosave -> Update Os is "Time monitoring error on receiving data". I tried null cable modem and cross cable and does not work. Is there anything else to do ?
dguillize Posts: 2 Rating: (0)
Suggestion To thank Quote Answer

3/2/2006 3:09 PM	Rate (0)
Nemo Posts: 3149 Rating: (171)	Hi the PTU-Update must work : http://support.automation.siemens.com/WW/view/en/13031616 check your null modem cable: http://support.automation.siemens.com/WW/view/en/21401061 nemo
Nemo Posts: 3149 Rating: (171)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on