Default Header
(header konnte nicht geladen werden)
Navigation
Rating 
Thanks 0
4 Entries
| 6/2/2014 1:27 PM | |
|
Posts: 6 Rating:
|
I would like read all information only from PLC. I have CPU1211 DC/DC/DC with FW4.0 Kelu I have seen seen page 315 in s71200_system_manual_en-US_en-US.pdf This is only description of function. I don't see any addresses, which I can use. |
Last edited by: CS Moderator at: 6/4/2014 12:32 PMnew subject after splitting from /tf/WW/en/Posts/108621#top |
|
| 6/2/2014 2:29 PM | |
|
Posts: 88 Rating:
|
I didn't know what do you want exactly... Because it depends on your application... What is the module do you want to read? HERE you can find perhaps something. Regards, |
| 8/7/2014 3:47 PM | |
Joined: 9/1/2005 Last visit: 10/31/2025 Posts: 4114 Rating:
|
new question published by Simon Gibsonis split to a seperate thread with the subject CPU1211 - What parameters did you use to retrieve the PLC information?. Best regards CS Moderator |
|
My Forum is the place to personalize your profile, |
|
Follow us on