Skip to Content

Register Login

Default Header

(header konnte nicht geladen werden)

Navigation

KTF700F no Profisafe Connection

Created by: AutoGen_5093819 at: 2/5/2024 4:51 PM (3 Replies)

Rating (0)

Thanks 0

4 Entries

2/5/2024 4:51 PM	Rate (0)
AutoGen_5093819 Posts: 1 Rating: (0)	Hello, PLC 1517F Firmware 3.0.3 with TIA V18 I have installed new KTF700F Mobile and updated them to V17.00.00.05_02.01 I have the F_FB_KTP_Mobile Block in my safety but the Status is not changing when i connect the Panel. The normal communication is working but not the safety. I checked if the inputs from the block are matching with my HW config. I cross checked all the Settings on the Panel (IP Adress, Profisafe enable and the name / i made an NTP connection to the plc so the time is matching, I set the E - Stop evaluation to Profinet and but in the right Box ID) I tried to rebuild my safety a few time and changing some setting in Profisafe and on the PLC. But nothing is helping I even removed all passwords from my plc I recompiled the panels and loaded I did the Firmware update over Tia Portal and over Prosaver
AutoGen_5093819 Posts: 1 Rating: (0)
Suggestion To thank Quote Answer

2/9/2024 7:47 AM	Rate (0)
Murof Platinum Expert Joined: 8/3/2009 Last visit: 9/3/2025 Posts: 16320 Rating: (1930)	Hello AutoGen_5093819 everythinig sounds OK in your description. Perhaps you can use the basic application to go through and check your project (perhaps you are missing some step): https://support.industry.siemens.com/cs/de/en/view/103497649 Bye Murof
	If this Information really helps, you could use the Rate function
Suggestion To thank Quote Answer

4/24/2025 5:26 PM	Rate (0)
AutoGen_1990022 Joined: 2/23/2022 Last visit: 4/25/2025 Posts: 1 Rating: (0)	What was the solution? We have the same problem. Thanks in advance

Suggestion To thank Quote Answer

4/30/2025 1:29 PM	Rate (0)
Murof Platinum Expert Joined: 8/3/2009 Last visit: 9/3/2025 Posts: 16320 Rating: (1930)	AutoGen_1990022 What was the solution? We have the same problem. Thanks in advance Hello do you have activated the Profinet Settings on the Mobile Panel in the Control Panel? Bye Murof
	If this Information really helps, you could use the Rate function
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on