smiffy

1) You will need to use the PORT_CFG block to setup the serial parameters. I suggest that you use 9600 baud, 8 data bits, 1 stop bit and no parity, and no flow control. You will need to set REQ high and wait for DONE to be set true and STATUS = 0. This will indicate that the serial port on the CM 1241 has been configured.
2) Configure hyperterminal to the same serial setup.
3) Connect the PC to the CM 1241 using a suitable cable (transmit and receive lines should be crossed and ground connected to ground).
4) Call up the CM 1214 from within hyperterminal.
5) To receive data on the CM 1214 you will need to use the RCV_PTP block. Configure the block as instructed in the S7-1200 system manual. Connect a suitable storage area to the BUFFER input (this would normally be a shared DB). Set EN_R true. Now any data that is type on the PC keyboard will be placed in the storage area supplied at the BUFFER input.
6) To send data from the CM 1214 you will need to use the SEND_PTP block. Configure the block as instructed in the S7-1200 system manual. Connect a suitable storage area to the BUFFER input (this would normally be a shared DB). Connect a suitable rising edge generator to the REQ input. You could use a JK flip-flop with both the J and K inputs set high running in a cyclc OB to do this. This will generate a rising edge at half the frequency of the cycle time of the OB. The data that is loaded to the storage area DB will then be displayed in the hyperterminal window.

I suggest that you read section 12.3 (Point-to-Point (PtP) communication) of the S7-1200 system manual.

 thanks very much for the instructions.

I'm having the same problem just right now, I'm using the SEND_PTP function in a FC written in SCL, them the FC it is not active all the time, just when its called them comparing the function enable and the rising edge of the SEND_PTP it will never occur after the second cycle, this trick solved: call the function twice. 

The first with a REQ:=FALSE them REQ:=TRUE. DONE!

//Send TVPro tightening frame

//"SEND_PTP_DB"(REQ := #print,"PORT" := #port, BUFFER := #frame, LENGTH := 18, PTRCL := 0);

//

"SEND_PTP_DB"(REQ:= FALSE,

              "PORT":=#port,

              BUFFER:=#frame,

              LENGTH:=18,

              PTRCL:= FALSE,

              DONE=> "%Q1.0",

              ERROR=>"%Q1.1");

"SEND_PTP_DB"(REQ := TRUE,

              "PORT" := #port,

              BUFFER := #frame,

              LENGTH := 18,

              PTRCL := FALSE,

              DONE => "%Q1.0",

              ERROR => "%Q1.1");

Dear Smiffy,

 any information,maximum how many bytes of data can be send in a single request ?

Hello,

look to attachment (from S7-1200 system manual). For any other infos look to manual.

Update: I've make test and again confirming, max. 1024 bytes I can send with one send.

Dear Durius,

Really thank you for the information.

I was searching in the module catalogue as well as send PTP instruction on length area, but couldn't trace any useful information...

If i need to send more than that, any possible way ?

Say by changing buffer address via program or something like that ? Currently i don't have hardware to check..

Dear Kaulquappe,

thank you for the update.

Is there any other module available in 1200 series which can send minimum 1300 bytes/frame ? any idea