Hi,

Is it possible to connect to the RF680R using any public OPC UA client program?

Yes it is. Please try this one

Is it possible to connect without any certificate?

Yes. The following is valid for the latest FW

In the web interface go to: settings --> Communication --> OPC UA settings

activate "OPC UA interface"

select "Parallel"

In the security settings:

select "No security"

select "Allow anonymous access"

Do we need a license for all functionalities?

Not for the reader.

You really should update to the latest firmware version.

AutoGen_242158

Hi,

Is it possible to connect to the RF680R using any public OPC UA client program?

Yes it is. Please try this one

Is it possible to connect without any certificate?

Yes. The following is valid for the latest FW

In the web interface go to: settings --> Communication --> OPC UA settings

activate "OPC UA interface"

select "Parallel"

In the security settings:

select "No security"

select "Allow anonymous access"

Do we need a license for all functionalities?

Not for the reader.

You really should update to the latest firmware version.

 Thank you so much for your advice. you have talked about Select "Parallel."

I can't find this setting in WBM. Can you check it in my attached. If I don't set it , what happen?

The firmware you're using doesn't support parallel access. The settings mentioned above are related to the latest version of the firmware.

The old firmare allows only one application, to avoid problems that could occur, when two appliactions are trying to control the reader at the same time.

Paralell access is possible for diagnostic purposes in later versions of the firmware.

AutoGen_242158

The firmware you're using doesn't support parallel access. The settings mentioned above are related to the latest version of the firmware.

The old firmare allows only one application, to avoid problems that could occur, when two appliactions are trying to control the reader at the same time.

Paralell access is possible for diagnostic purposes in later versions of the firmware.

 Wow !! This is a big information for making the configuration that I want to. Could you link me to the late version of the firmware? It would be greatly appreciated if you could do that.

Thank you very much , Mr. expert.

I have just downloaded the firmeware at the link. when I click SHA-256 , I can see Checksum number. this is also needed when I upgrade the firmware to RF680R ?  in addition , Could you also link me to the manual how to upgrade ?

The  SHA-256 is only intended to ensure the integrity of the firmware file. It's not needed to load the firmware.

The firmware can be loaded in the system section of the web interface.

Wow! Thank you so much for all the information. You're a lifesaver! I'll follow all your instructions.

have an amazing rest of the day !!!

Dear Mr. Expert

Thank you very much for your great instructions.

I followed your instructions for using OPC UA and successfully accessed it via the UA Expert application on my laptop.

Additionally, I want to test RS422 serial communication while accessing OPC UA. However, after upgrading the firmware to version 4.0.2, RS422 does not seem to be working properly.

Originally, we were using a Beckhoff PLC that communicates with the RF680R reader via RS422.

I have confirmed that parallel access is enabled in the OPC UA settings.

How can I check whether RS422 is working correctly alongside OPC UA?
Is there any test application that I can install on my laptop to test the RS422 communication of the reader?