Navigation

WINCC version problem

Created by: Engin Safak at: 5/23/2012 3:55 PM (1 Replies)

5/23/2012 3:55 PM	Rate (0)
Engin Safak Posts: 14 Rating: (0)	Hello, I have a problem about WINCC version. My WINCC version is WINCC 2008 SP2 Upd13 . Now, I can not open a S7-400 PLC project. This project is giving a failure. How can I open this project? Failure massage: The project was created with an incompatible or beta version of WINCC flexible. It was last opened with (V 1.4.0.0 (1.16.16)). Open the project with a valid WINCC flexible version. If it was a beta version, use the offical release version.
Engin Safak Posts: 14 Rating: (0)	Last edited by: Engin Safak at: 5/23/2012 4:19 PM Last edited by: Engin Safak at: 5/23/2012 4:18 PM
Suggestion To thank Quote Answer

5/24/2012 9:11 AM	Rate (0)
Darius Platinum Expert Joined: 9/28/2005 Last visit: 11/5/2024 Posts: 2957 Rating: (242)	Engin Safak Hello, I have a problem about WINCC version. My WINCC version is WINCC 2008 SP2 Upd13 . Now, I can not open a S7-400 PLC project. This project is giving a failure. How can I open this project? Failure massage: The project was created with an incompatible or beta version of WINCC flexible. It was last opened with (V 1.4.0.0 (1.16.16)). Open the project with a valid WINCC flexible version. If it was a beta version, use the offical release version. Look at this forum post, especially last post https://www.automation.siemens.com/tf/WW/en/Posts/64503 Seems that user found a solution. Also look here https://www.automation.siemens.com/tf/WW/en/Posts/39461
	Best regards, Darius
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users Lucky123